Nonlinear performance evaluation model for throughput of AQM scheme using full factorial design approach

The performance of active queue management (AQM) is measured in terms of throughput, delay, queue size, and loss rate. We have carried out the optimized performance measure of throughput for AQM scheme random early detection (RED) using full factorial design (FDD) technique that is a new approach of performance analysis particularly for congestion control algorithms. We have considered the input factors, viz, buffer size, maximum threshold, and the number of file transfer protocol (FTP) sources for the evaluation of RED that can be used for other AQM schemes, viz, adaptive RED, three‐section RED (TRED), and adaptive queue management with random dropping (AQMRD). The effect of each input factor as well as their interactions are evaluated using factorial design technique that results to obtain the nonlinear equation for performance measure in terms of input factors buffer size, maximum threshold, and the number of FTP sources. Finally, we show the contour plots for variation of performance measure throughput (steady state) from minimum to maximum values with respect to the different setting of input parameters.     

无扩口导管拧紧力矩对其密封性能的影响

以某型飞机中无扩口液压导管为研究对象,结合飞机液压导管实际安装以及保压工况,利用有限元软件ANSYS中多线性随动强化来模拟导管弹塑性本构模型;对处于不同安装力矩以及恒定压力下的导管连接件进行仿真分析,研究安装力矩对导管管接头处的应力应变以及密封性能的影响,并给出参考安装力矩。构建液压导管安装试验台,利用力矩扳手采集拧紧力矩值并使用液压油车对导管进行加压试验,验证不同安装力矩对导管管接头密封性能的影响。结果表明:导管与卡套之间的胀形区域产生的大变形以及应力集中是引起导管管接头渗漏的主要原因之一;所提出的密封性能仿真方法可以较为准确地模拟拧紧力矩与密封性能的关系,为实际工程中导管安装提供依据。     

企业社会责任对跨国并购绩效的影响——基于沪深A股上市企业的实证研究

为了帮助我国企业在跨国并购交易中更好地应对因企业社会责任表现所引起的跨国并购风险，平衡好经济利益诉求与社会责任的履行，论文以2009—2017年沪深A股上市公司109起成功的跨国并购事件为研究对象，基于利益相关者理论、社会契约理论与委托代理理论，研究了企业社会责任对于跨国并购绩效的影响，同时考虑了企业所有制、行业一致性和跨国并购经验的调节作用。采用多元回归模型的实证结果表明：1）企业社会责任对跨国并购绩效存在显著的正向影响；2）企业社会责任与跨国并购之间的正向关系受到国有属性与跨国并购经验的负向调节；3）当并购双方属于同一行业时，行业一致性会显著促进企业社会责任对跨国并购绩效的正向影响。建议企业主动披露企业社会责任履行状况并引入国际通行标准，也可借助国际公关公司制定企业社会责任战略。以上研究结论对中国企业履行社会责任方面具有一定的指导意义，同时也为跨国并购绩效的影响因素研究提供了新的理论视角。     

Effects of inter-electrode insertion on the performance and thermal flow fields of a hollow-electrode plasma torch

The effects of inter-electrode insertion on the performance of a hollow-electrode plasma torch have been investigated by numerical analysis. Simulation results revealed that when inter-electrodes are inserted, the arc voltages and plasma powers increase due to the increase in the arc length. In addition,it was predicted that thermal efficiency can be improved with the increase in plasma power by injecting plasma gases through the gaps between inter-electrodes. These unique effects of inter-electrode insertion are a result of the plasma temperatures adjusting themselves to increase arc voltages when the arc column is contracted radially by increasing gas-flow rate or decreasing inter-electrode diameter.     

低阶煤热解条件对高炉喷吹半焦燃烧性能及动力学特性的影响

采用热重分析法研究了不同热解条件下半焦的燃烧性能和动力学特征，利用Ozawa法求取动力学参数。结果表明，热解温度越低、保温时间越短时，半焦的燃烧性能越好；热解升温速率对半焦燃烧过程的反应程度影响不大；粒度越大，燃烧性能差异性越明显。热解温度对半焦燃烧性能影响较大，550℃是本研究中制备高燃烧反应性半焦的适宜热解温度。两种不同粒度原煤制得的半焦均随转化率增大，活化能减小。1~3 mm原煤在热解温度为550℃时所得半焦在燃烧过程中符合反应级数模型，化学反应为限制性环节，反应最概然机理函数为f(α)=(1–α)2。     

封隔器胶筒高温高压密封性能检测试验研究

设计研制一种封隔器胶筒密封性能试验装置。该装置可模拟油井下350℃高温、20 MPa高压恶劣工况,能够模拟封隔器胶筒坐封过程,能够对封隔器胶筒的密封性能进行检测。借助试验装置对不同形式的胶筒进行环空密闭试验,测试了不同形式封隔器胶筒在不同介质下环空腔内压力变化规律,得到了试验后胶筒的形变状态、腐蚀破损情况,检验了各形式胶筒在高温高压工况下的密封性能,为封隔器胶筒的设计和改进提供可靠的试验依据。     

煤层软硬分层吸附瓦斯性能差异性及其对瓦斯赋存的影响

为研究煤层软、硬分层吸附瓦斯性能差异性及其对瓦斯赋存的影响,分析了煤层内软分层的形成机理及结构特征,采集了我国多个煤与瓦斯突出矿井的煤样作为试验对象,应用高压容量法开展了软、硬分层煤样吸附瓦斯性能参数的对比试验,探讨了软煤、硬煤吸附性能的差异性。在此基础上,对煤层软、硬分层吸附瓦斯性能差异性与瓦斯赋存特征之间的关联进行了研究,结果表明:试验煤样软分层的极限吸附量均大于硬分层;随着瓦斯压力的增加,试验煤样软、硬分层瓦斯含量的差值逐渐增大,其曲线的变化特征与Langmuir方程类似,并且软、硬分层瓦斯含量数值的差异主要由吸附量差值构成;煤层软、硬分层吸附瓦斯性能的差异不仅对煤层原始瓦斯赋存特征有着显著的影响,同时还将影响煤巷掘进、瓦斯抽采过程中煤体内瓦斯流场的分布规律,需要根据煤层软、硬分层的组合特点,制订切实有效的瓦斯抽采技术方案。     

超高效液相色谱串联质谱法测定烟草中的噁霉灵残留

为降低烟草中噁霉灵检测中的基质干扰，提高检测灵敏度和和稳定性，通过试验建立了以QuEChERS为样品前处理方法、液相色谱串联质谱仪为检测仪器的烟草中噁霉灵残留检测方法。样品加水浸润后，经丙酮提取、盐析试剂包除水、石墨化炭黑除杂后，采用Agilent ZORBAX 300SB-C8液相色谱柱（2.1 mm×100 mm，1.8 μm）分离，甲醇-水程序洗脱，ESI雾化，串联质谱MRM检测。结果发现，该方法在0.0025~0.0500 mg/L范围内线性良好，决定系数r²=0.9996，定量检测限1.06 μg/L，回收率在90.8%~92.0%之间，相对标准偏差为5.1%。运用该方法测定烟草中的噁霉灵，操作简单，检测精度高，满足CORESTA对烟草农残检测的要求。     

Comparative study of Ti-C-Ni-Al,Ti-C-Ni-Fe,and Ti-C-Ni-Al/Ti-C-Ni-Fe coatings produced by magnetron sputtering,electro-spark deposition,and a combined two-step process

Comparative study of Ti-C-Ni-Fe, Ti-C-Ni-Al, and Ti-C-Ni-Al/Ti-C-Ni-Fe coatings obtained by electro-spark deposition (ESD) using TiCNi electrode, magnetron sputtering (MS) of TiCNiAl target, and a combination of these methods (MS-ESD) was carried out. The coating microstructures and elemental compositions were studied by means of X-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, and glow discharge optical emission spectroscopy. The materials were tested in terms of their hardness, elastic modulus, elastic recovery, crack resistance, friction coefficient, and wear resistance under sliding, impact and abrasive conditions, as well as corrosion- and oxidation resistance. The work demonstrated that the utilization of a combined two-step MS-ESD technology permits to obtain bilayers made of Ti-C-Ni-Al/Ti-C-Ni-Fe coatings with improved crack-, wear- and oxidation resistance compared with their single-layered Ti-C-Ni-Al counterparts deposited by MS, and with reduced friction coefficient and enhanced corrosion resistance compared with ESD Ti-C-Ni-Fe coatings.     

Two‐sided matching framework for optimal user association in 5G multi‐RAT UDNs

Recently, academic and industrial research communities are paying more explicit attention to the 5G multiple radio access technology ultra‐dense networks (5G multi‐RAT UDNs) for boosting network capacity, especially in UD urban zones. To this aim, in this paper, we intend to tackle the user association problem in 5G multi‐RAT UDNs. By considering the decoupled uplink/downlink access (DUDA), we divide our user association problem into two distinct subproblems representing, respectively, the uplink and the downlink channels. Next, we formulated each one as a nonlinear optimization problem with binary variables. Then, to solve them, we were restricted by the hard complexity, as well as the hard feasibility of centralized user association schemes. Thus, to resolve our user association problem in a reasonable time and distributed manner, we formulated each subproblem as a many‐to‐one matching game based on matching theory. Next, we provide two fully distributed association algorithms to compute the uplink and downlink stable matching among user equipments (UEs) and base stations (BSs). Simulation results corroborate our theoretical model and show the effectiveness and improvement of our achieved results in terms of the overall network performance, quality of service (QoS), and energy efficiency (EE) of UEs.